Artisan Technology Group Quest 210 Specifications download pdf (Page 24)

Connect the Reactor Unit Manifold Tubes

The Solvent Bottle Cap has

female ports oriented in a "Triangle." (see diagram)

Figure

1-4

Solvent Bottle Cap

Female Ports

pFq

Solvent

Connect the umbilicus tubes labeled "Btl. Press" and "Solvent" to the corresponding

ports on the Solvent Bottle Cap.

the accessory kit, there will be a tube with a fitting on only one end, this tube

connects to the vent port of the Solvent Bottle Cap.

Use the dial on the top of the Solvent Bottle Cap to select between Pressure and Vent

for a Solvent Bottle.

NOTE

Note

When the dial is turned to "Vent" gas and Solvent fumes will escape

through the tube connected to the "Vent" Port of the Solvent Bottle Cap. Point this tube

towards the rear of the fume hood, or tape it down to a convenient spot in the fume hood.

Connect the Reactor Unit Manifold Tubes

For installation it is required to connect

tubes

on each side of the Quest) from

bulkhead fittings on the upper area of the Quest Reactor Unit to female ports on the

Quest Upper Manifold.

The tubes are located in the accessory kit. There will be 4 short tubes and 2 that are

somewhat longer. Each tube will have a bushing-ferrule unit on each end.

The tubes

are labeled as follows:

Man. Deliv.

each)

Man. Vent. (2 each)

Mem Press.

each

longer tubes)

QUEST

User Manual

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 97 98

No comments

Artisan Technology Group Quest 210 Specifications Page 24