Artisan Technology Group Quest 210 Specifications Page 41
- Page / 98
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
System
Overview
Controller Unit
LCD
Screen and Keypad
The Controller Unit
LCD
screen and keypad allow you to set the reaction temperature,
temperature duration, and agitation parameters.
LCD
Display
The
LCD
display presents the various Quest programming screens. These screens allow
you to change reaction temperature, temperature duration, and agitation parameters.
Also, the screens will display status on the agitation and temperature settings.
Use the key pad buttons to move between screens, select a parameter on the active
screen, and increase or decrease the value of the chosen parameter. For more
information on the Mode, Forward and Back, Parameter,
STARTISTOP, and Agitator
ON control box buttons, see the definitions provided in this section.
The possible display screens are as follows:
Sign-on Screen
-.identifies this instrument as Argonaut
Technologies' Quest 2 10
Firmware Version Screen
-
shows the Quest 210 firmware version
number
Agitation Control Screen
-
allows you to set the agitation parameters.
You can set three agitation parameters on this screen:
MixEveryseconds, Upstroke, and
%
Upward parameters.
The MixEvery-seconds selection is where the agitation frequency is set (the time
between consecutive up-strokes.)
The Upstroke parameter is the amount of time the agitation bar will be in the upper
position (This number is necessarily less than the agitation frequency value). This time
begins with the Upstroke initiation and ends with downstroke initiation.
The
%
Upward parameter controls the upstroke in the same manner as the "Upstroke"
parameter, but is expressed in terms of a percentage of the agitation frequency, rather
than a time.
Set Temperature Screen
-
allows you to set a temperature for each of
the 2 reaction vessel banks, turn on the heaters, designate how long
each reaction vessel bank should remain at this temperature, and also
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
- 1
- Manual Synthesizer 2
- Table of Contents 4
- Specifications 7
- Symbols 8
- User Supplied ltems 9
- Limited Warranty Agreement 10
- EXCLUSIONS 11
- IS NOT COVERED) 11
- SITE PREPARATION 12
- INSTALLATION 12
- Immunity Information 13
- Maintenance 14
- Contact Information 15
- Overview 17
- Quest Installation Procedure 19
- Installation Procedure 20
- Introduction 21
- Umbilicus Connections 21
- Procedure 22
- Solvent 24
- Install the Glass Waste Tank 27
- Connect Power to the Unit 28
- Install a 4L Solvent Bottle 28
- System Overview 30
- Reactor 31
- Reaction 32
- Heating and Cooling 32
- Manifold 34
- Manifold Control Valves 35
- Metered Gas Needle Valve 36
- Utility Ports 36
- WARNING Always place the 37
- Waste Tray and Container 39
- Sample Collection 39
- Collection Racks 39
- Controller Unit 40
- Screen and Keypad 41
- Mode Button 42
- Forward and Back Buttons 42
- Parameter Setting Buttons 42
- Controller 43
- System Gas 44
- Electrical Outlet 44
- Power Switch 44
- Operating the Quest 46
- Remove Old Reaction Vessels 47
- Reaction Vessels 48
- Temperature 50
- 5mL 5mL 50
- Repeat this 52
- WARNING 53
- Starting a Reaction 55
- MixEvery 56
- Agitating 56
- Operating the 57
- NOTE The agitator needle 58
- Temperature Control 59
- 3/32" 61
- Parallel Solvent Addition 63
- Changing 67
- Solvent Bottle 67
- Quest 210 69
- Providing 70
- Collection Rack Options 71
- Troubleshooting 76
- Glossary 78
- Appendix 82
- Control Box 82
- Display Screens 82
- Quest Controller Box and 83
- Display 83
- Sign-on Screen 84
- Firmware Version Screen 85
- Agitation Control Screen 86
- FORWARD/BACK 87
- Set Temperature Screen 88
- Monitor Temperature Screen 89
- Other Functions Screen 90
- Results 91
- ERWARDIBACK 92
- Self Test Screen 93
- Heaters screen appears 94
- Starts/Stops agitation 94
- Restore Defaults Screen 95
- StartEtop Heaters 96
- Plumbing Schematic 97
Related products and manuals for Synthesizer Artisan Technology Group Quest 210
(42 pages)© 2020, manymanuals.com. All rights reserved. | 0.143 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals