Artisan Technology Group Quest 210 Specifications download pdf (Page 69)

Operating

the

Quest 210

Starting

Reaction

Adding Solvent or Reagents Through the Luer Ports

Solvents, liquid reagents and solids can be added to the reaction vessels through the luer

ports located at the top of the upper manifold. Typically, these reagents are added via

syringe or pipette.

Prior to adding solvents or reagents through the luer ports, it is recommended that

the system be vented, as it may be under pressure. To vent the vessels, rotate the

Manifold Control Valves as shown below. Slowly approach the "Vent" setting on

the valve to vent the pressure slowly to avoiding "bumping" the solution.

drain

solvent closed

utility

metered gas

vent

closed

utility

After placing the Manifold Control Valve to the "Vent" position, slowly remove the

her plug by rotating the plug as it is pulled back.

WARNING The reaction vessel contents may be under pressure. Wear safety glasses,

gloves and appropriate clothing.

Do not open the upper luer ports when the RVs are being heated. Turn off the heaters

and allow the vessels to return to ambient temperature.

To add liquid reagents or solvents, use a syringe with needle, or pipette.

WARNING Be careful not to score the interior surfaces of the her port with the

needle, as marring the surface can affect the sealing of the her port.

For solids, use a spatula or weigh paper to add the solids. If residual solid is present

on the interior luer bore surface, rinse the solid down with a small amount of

solvent.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 97 98

No comments

Artisan Technology Group Quest 210 Specifications Page 69