Artisan Technology Group Quest 210 Specifications download pdf (Page 61)

Operating the Quest

210

Starting

Reaction

Make sure that the vessel size selection in the Set Temperature screen matches the

size that is being used for the synthesis. If not modify the selection in the screen.

10.

The temperature set point can be changed from an existing set point, by using the

Set Temperature screen.

11.

The heaters will turn off when the time has elapsed, or they can be stopped

immediately by pressing the

STARTISTOP

button with the cursor on the

LCD

line

corresponding to the

bank.

12.

desired, press Mode button to view the Monitor screen. This screen will display

the set point and the actual

temperature.

Chilling the Reaction Vessels

For sub-ambient temperature set points, an external recirculating chiller is required.

Set the low temperature set-point into the Controller Unit in the same manner as was

described previously for heating.

Use the chiller on only one side of the Quest.

a second chiller is available, then both

sides of the Quest can be chilled together.

Connect the Chiller Fitting Kit Accesory to the Quest

Figure

3-8

Quest

Chiller

Fitting

Accesory

a.Using a

3/32"

hex wrench, remove the

screws fastening the heater block guard

to the front of the heater assembly.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 97 98

No comments

Artisan Technology Group Quest 210 Specifications Page 61