Artisan Technology Group Quest 210 Specifications download pdf (Page 71)

Operating the Quest

Starting a Reaction

To stop the gas flow set the Manifold Control Valves as follows:

drain

solvent closed

utility

metered

gas

vent

closed

utility

Collection of Liquid Reaction Products

When it is time to collect reaction products from the Quest, the waste container can be

removed and an appropriate collection rack installed. Position the collection rack on the

waste tray, raise the rack up until the tubes on the Lower Manifold Drain Block are

below the lip of the vials, and lock in place using the buttons on the handles.

NOTE For product collection, use the

psi Metered Gas, as opposed to the

psi

Drain Gas to provide the head pressure for fluid transfer. Using the higher pressure can

result in splashing.

Collection Rack Options

Collection racks

are

holders that can contain up to 20 screw top tubes or vials into which

you can collect product. The following racks are available for product collection:

A rack for

13mm

100

screw cap tubes

A rack for 20

or 40

rnl

scintillation vials

Draining Synthesis Products to the Collection Vials

----

WARNING

During product collection, there can be

small amount of splashing.

Wear safety glasses, gloves, and appropriate clothing.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 97 98

No comments

Artisan Technology Group Quest 210 Specifications Page 71