Artisan Technology Group Quest 210 Specifications download pdf (Page 27)

Introduction

Quest Installation Procedure

Screw in the bushing for one end of the tube labeled

"Man.

Del." to the remaining red

bulk head fitting located on the front face of the upper Reactor Assembly. This will be

the lower port of a set of

mounted together. Screw the other end of the tube into the

female threaded port on the Upper Manifold at the right of the "triangle of ports (see

diagram)."

Repeat the tubing installation for the other side of the Quest Reactor Unit.

Install the Glass Waste Tank

Unpack the rectangular Glass Waste Tank from the box.

On the Quest Reactor Assembly, grasp the handles on the lower Waste Tray. Press the

buttons on the handles and move the tray to its lowest position. Carefully place the

Glass Tank on the tray, and raise the tray back to its upper position, so that the waste

tank mates with the Drain manifold.

Set the Manifold Control Valves to Closed

Check the orientation of the Manifold Control Valves. The two valves on both sides of

the Quest Reactor Unit should be set to "Closed."

drain metered gas

solvent

closed vent

closed

utility

Connect Gas to the Quest Controller

The system gas to run the Quest is installed

via

a "Quick Connect" fitting on the right

rear of the Quest Controller Unit.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 97 98

No comments

Artisan Technology Group Quest 210 Specifications Page 27