Artisan Technology Group Quest 210 Specifications download pdf (Page 44)

Control Box Connections to the Reactor Assembly

The control box has connections for the Umbilicus for interface to the Reactor Unit.

These ports are:

Heater Power

Supplies power to the heaters within each reaction

vessel bank.

Signal

This cable carries thermocouple readings from the Reactor

Unit to the Controller Unit.

Agitation Gas

Two ports on the Controller unit supply

gas to the

pneumatic gas cylinder.

Solvent Gas Pressure

port on the Controller Unit is used to supply

gas pressure to the Solvent Bottle Assembly.

Drain Gas

The drain gas port supplies 30 psi gas line from the

Contoller Unit to the Reactor Unit.

Metered Gas

The drain gas port supplies 10 psi gas line from the

Contoller Unit to the Reactor Unit, and is flow regulated by a needle

valve on the Reactor Unit.

Controller Unit Gas and Power Connections

System Gas

The gas port (located on the rear of the Controller Unit) uses Quick Connect fittings to

interface with a inert house gas system. A minimum of 30 psi is required. (Maximum

pressure

40 psi)

Electrical Outlet

The power cord connects to the rear of the Quest Controller Unit. The instrument can

operate on 90-240 VAC wall outlets.

Power Switch

After you have plugged in the power cord to the power outlet, the power switch turns

the power on or off.

QUEST

210

User

Manual

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 97 98

No comments

Artisan Technology Group Quest 210 Specifications Page 44